Connecting the Video Cable
1.Connect one end of the computer video cable to the projector’s Computer 1 (VGA) port.
Computer 1 (VGA) port
computer video cable
2.Make sure the DVI/VGA switch on the back panel is flipped to the right, as shown. If necessary, use the tip of a ballpoint pen to slide it over.
DVI/VGA switch (slide to right)
Computer 1
Computer 2 /Component Video
R/Cr/Pr | G/Y | B/Cb/Pb H/C Sync V Sync |
3.Connect the other end of the
video cable to the laptop’s video (monitor) port.
4.Tighten the screws on the connectors.
If you don’t need to make any other connections, you can plug in your projector and turn it on. See page 40 for instructions.
Setting Up the Projector 21