6.Install the roll paper holders on the printer.

Insert the left holder into the far left slot, then insert the other holder into the appropriate slot on the right (either the 4-inch slot as shown, or the 8.3-inch slot further on the right).

7.Pull out approximately 15 inches of paper and insert it

into the roll paper feeder. Then slide the edge guide snugly against the paper.

Caution: Don’t load roll paper into the sheet feeder at the top of the printer.

8.Push the paper into the roll paper feeder as far as it will go (about 10 inches). Hold the paper in place for a few seconds, until the printer feeds it automatically.

Don’t load roll paper in the cut sheet feeder

Roll paper feeder

9.To verify that the paper is loaded straight, open the printer cover and look into the printer.

Printing on Roll Paper, CDs, DVDs, and Card Stock 35