As the program checks each track, it decreases the cylinder numbers to zero. When the test is complete, the program displays a report on the status of the disk, such as the following:

Analysis finished.

Count

of

tracks flagged bad

=

n

Count of tracks with read,

verify errors =

n

Count

of

good tracks= nnnn
No read, verify error was detected.

If the program finds errors, the screen displays a table of the tracks that produced the errors. Then you see this message:

Press ENTER to return to the menu.

Check the information displayed. Then press m to return to the Hard Disk Format Menu.

Exiting the Program

To leave the Hard Disk Format Menu, select Exit . You see a prompt to insert the Reference 1 diskette. Remove the Reference 2 diskette, insert the Reference 1 diskette, and press [Enter. Now you can use any of the other utilities or return to the Main Menu.

If you formatted the hard disk or ran the Destructive surface analysis option, you must now prepare your hard disk for use with your operating system. See your operating system manual for instructions.

B-12Formatting a Hard Disk