![](/images/new-backgrounds/1169657/169657201x1.webp)
■When the Indicators Provide No Help
Refer to each relevant item if the following situations arise but the indicators provide no help.
· | The image is not projected | page 99 |
· | No sound | page 106 |
· | The image is unclear | page 103 |
· | The remote control will not work | page 106 |
· | The image is cut up (Large)/Small | page 104 |
· | Cannot end | page 107 |
· | The image color is bad | page 105 |
· | The image is dark | page 105 |
The image is not projected
●Nothing is displayed
●Is the Lens Cover still in place? see page 35
●Has the power been switched off and then on immediately? The [Power] button will not operate after projection has been finished (during the cooling down procedure). The [Power] button will work again after the cooling down process Projection lamp
Nothing is displayed | (cooling operations: the operation indicator is illuminated in orange) | |
has been completed. | ||
| ||
| see page 45 | |
| ● Is the Sleep Mode set at ON? | |
| When the sleep mode has been set at [ON], the lamp will be | |
| automatically extinguished if no operations occur and no signals are | |
| input for a period of thirty minutes. | |
| see page 67 | |
| ● Did you press the [Power] button? | |
| see page 37 | |
| ● Has the brightness of the image been correctly adjusted? | |
| see page 65 | |
| ● Is the system in the [A/V Mute] mode? | |
| see page 51 | |
| Perform the reset procedure. | |
| see page 68 | |
| ● Is the input image completely black? | |
| There are cases where input images will become completely black | |
| owing to screen saves, etc. | |
| ● Are image signals being input? | |
| No message will be displayed when the [Menu] - [Settings] and [No | |
| Signal Display] parameter is set at [OFF]. Set either black or blue to | |
| display the message. Refer to each relevant item when the message | |
| is displayed. | |
| see page 100 | |
| ● Perform the reset procedure. | |
| see page 68 |