112 - Replacing the Lamp
EMP-715/505E mainte.fm
Replacement method
1Switch off the power supply, allow the projector to cool down*, and then disconnect the
Power Cord.
The amount of time required for the projector to cool down will depend on the surround-
ing temperature.
2Wait until the lamp has cooled down sufficiently, and then remove the lamp cover.
·Approximately one hour is required for the lamp to cool down sufficiently.
·Loosen and remove the screw holding the fan in place.
3Withdraw the lamp.
Loosen the two screws holding the lamp in place, and then pull the lamp out towards you.
4Attach a new lamp.
Align the direction, push the lamp in as far as it will go, and then secure it in p lace with
the two screws.
715_505E.bk Page 112 Friday, May 25, 2001 10:24 AM