Epson EMP-TW1000 U Problem Solving, warning/problem, : Lit : Flashing, Orange High-speedcooling in progress, Red High internal temperature (overheating)

Problem Solving

Reading the indicators

The projector is provided with the following two indicators which notify you of the operating status of the projector.

The following tables show what the indicators mean and how to remedy the problems that they indicate.

*If all indicators are switched off, check that the power cable is connected correctly and that the main power switch is on.

(operation) indicator

(warning) indicator

When the (warning) indicator is lit or flashing warning/problem

: Lit : Flashing

Red

(Lit/off for

1 sec)

Internal problem / Fan problem / Sensor problem / Cinema filter problem / Auto iris problem

Disconnect the power cable from the electrical outlet. Then contact your local dealer or the nearest address provided in the World-Wide Warranty Terms. Inquiries

Red

(Lit/off for

0.5 sec)

Lamp problem / Lamp on error / Lamp cover open error

Check if the lamp is broken. p.46

Clean the air filter. p.44

		If the problem is still not solved after the lamp is
If the lamp is	Replace the lamp	replaced, stop using the projector and disconnect the
	and then turn the	power cable from the electrical outlet. Then contact
not broken	power on.	your local dealer or the nearest address provided
		in the World-Wide Warranty Terms.	Inquiries

If the lamp is

broken

Contact your local dealer for further advice.

Check that the lamp and the lamp cover are securely installed.

When using above an altitude of about 1500 m, make sure you set the "High Altitude Mode" to

"On". p.33

Red High internal temperature (overheating)

The lamp will switch off automatically and projection will stop. Wait for approximately 5 minutes. When the cooling fan stops, turn off the main power switch at the rear of the projector.

Orange High-speed cooling in progress

You can continue using the projector, but if the temperature rises again, it will switch off automatically.

•If the projector is installed against a wall, leave a space of 20 cm or more between it and the wall.

•Clean the air filters if they are blocked. p.44

If the problem is not solved when the power is turned back on, stop using the projector, turn off the main power switch, and disconnect the power cable from the electrical outlet. Then contact your local dealer or the nearest address provided in the World-Wide Warranty

Terms. Inquiries