Problem Solving

Problems relating to images■No images appear
Have you pressed the [Power]

Press

on the remote control or

on the projector’s control

button?

panel.

 

 

Is the main power switch

Turn on the main power switch at the rear of the projector.

turned off?

 

 

 

Are all of the indicators

Disconnect the power cable and then reconnect it. p.14

switched off?

Check the circuit breaker to see if power is being supplied.

Is blank mode active?Press on the remote control to cancel the blank function.

Is a video signal being input? Check that the power for the connected equipment is turned on. If the "Messages" menu command has been set to "On", messages relating to the image signals will be displayed.

"Settings" - "Display" - "Messages" p.34

Are the image signal format If a composite video or S-Video signal is being inputÅ

settings correct?If projection does not occur when the "Video Signal" menu command is set to "Auto", select the signal format that matches the signal source.

"Settings" - "Input Signal" - "Video Signal" p.34

If the signal source is connected to the [Component] or [D] input port

If projection does not occur when the "Component" in the "Input Signal" menu command is set to "Auto", set the signal format that matches the signal that is being projected from the connected equipment.

"Settings" - "Input Signal" - "Component" p.34

 

If the VCR or DVD equipment is connected using a D SCART

 

adapter

 

 

 

 

Press

to set the signal format to "D/SCART".

p.15

 

When still no images appear and the DVD equipment is connected,

 

change the setting at the DVD equipment to RGB output.

 

Have the configuration menu

Try resetting all of the current settings.

p.35

 

settings been made correctly?

 

 

 

 

Were the projector and computer

If the connection is made while the power is already turned on, the

connected while their power was

function [Fn] key that switches the computer's video signal to

already turned on?

external output may not work. Turn the power for the computer that

When a computer is

is connected to the projector off and then back on again.

 

 

 

 

 

connected

 

 

 

 

■Moving images are not displayed

Is the computer image signal set to output simultaneously both externally and to the LCD monitor?

Only when projecting images from a laptop computer or computer with a built-in LCD screen

Set the image signal to output only externally.

Computer documentation, under a title such as "External output" or "Connecting an external monitor"

38