Epson EMP-TW200H Problem Solving, When the, Reading the Indicators, (operation) indicator is lit or flashing normal, (warning) indicator is lit or flashing warning/problem

Problem Solving

Reading the Indicators

The projector is provided with the following two	(operation) indicator
indicators which notify you of the operating status of
the projector.
The following tables show what the indicators mean and
how to remedy the problems that they indicate.
*If both indicators are switched off, check that the
power cable is connected correctly and that power is	(warning) indicator
being supplied.

When the	(warning) indicator is lit or flashing warning/problem
			: Lit	: Flashing
Red	Internal problem / Fan problem / Sensor problem
	Disconnect the power cable from the electrical outlet. Then contact your dealer or
(1-second	the nearest address provided in the "International Warranty Conditions" section of
	the Safety Instructions/World-Wide Warranty Terms booklet.
intervals)
Red	Lamp problem / Lamp on error
	Check if the lamp is broken.		p.38
(0.5-second		Replace the	If the problem is still not solved after the lamp is replaced, stop
			using the projector and disconnect the power cable from the
	If the lamp is	lamp and
intervals)
			electrical outlet. Then contact your dealer or the nearest address
	not broken	then turn the
			provided in the "International Warranty Conditions" section of the
		power on.
			Safety Instructions/World Wide Warranty Terms booklet.

If the lamp is	Contact your local dealer for further advice.
broken

High internal temperature Red (overheating)

The lamp will switch off automatically and projection will stop. Wait for approximately 5 minutes.

Orange High-speed cooling in progress

You can continue using the projector, but if the temperature rises again, it will switch off automatically.

•When installing against a wall, leave a space of 20 cm or more between the projector and the wall.

•Clean the air filters if they are blocked. p.36

If the problem is not solved when the power is turned back on, stop using the projector and disconnect the power cable from the electrical outlet. Then contact your dealer or the nearest address provided at "International Warranty Conditions" in Safety Instructions/World-Wide Warranty Terms booklet.

When the		(operation) indicator is lit or flashing normal
When the		(warning) indicator is off			: Lit	: Flashing
Orange	Standby			If you press	, projection will start after a brief interval.
	condition
Green	Warm-up in			Warm-up time is approximately 45 seconds.
	progress			Power off operations are ignored while warm-up is in progress.
Green	Projection in			Normal operation is in progress.
	progress
Orange	Cool-down		in	Cool-down time is approximately 30 seconds.
				After cool-down is complete, the projector goes to standby mode.
	progress
30				You cannot use the remote control or the projector's control panel during cool-down.