Epson EPL-6200L Jam Detection Timing / Action to be Taken, Fuser Area Jam / Paper Eject Area Jam

EPSON EPL-6200/EPL-6200L Revision A

3.3.3 Jam Detection Timing / Action to be Taken

3.3.3.1Paper Feed Area Jam / Paper Transport Area Jam

† Detection Timing

Table 3-23. Paper Feed Area Jam / Paper Transport Area Jam

Category	Explanation
	After start of paper feeding, the Paper Feed Sensor turned ON
Jam detection in paper feed	earlier than the passage of the predetermined time.
area	The Paper Feed Sensor did not turn ON even after the passage of
	the predetermined period of time from start of paper feeding.
	After the Paper Feed Sensor turned ON, it turned OFF earlier than
	the passage of the predetermined time.
Paper eject area
	The Paper Feed Sensor did not turn OFF even after the passage of
	the predetermined period of time from turning ON of the Paper
	Feed Sensor.
Remaining paper detection	After start of paper feeding, paper transport stopped before the
in paper feed area	Paper Feed Sensor turned OFF.
	The Paper Feed Sensor was ON at turning on of the Main Switch,
Remaining paper detection	at opening and closing of the front door, at occurrence of a paper
	jam or at stop of paper transport.
in paper eject area
	At stop of paper transport, there is paper between the Paper Feed
	Sensor and the Paper Eject Sensor.

†Solution: Check the “Initial Check Items” (p.116) first and then replace the following components in the order named with new ones and repeat checking.

1.Paper Feed Solenoid (p.157)

2.Paper Feed Roller (Lower Cassette) (p.161)

3.Paper Feed Sensor (S1)

4.Eject Sensor (PS3)

5.Main Board Assy (C533/C534 Main) (p.146)

CHECK	Before replacing any electrical part, check to see if the part in
POINT	question is defective or not by consulting “3.5 Troubleshooting for
	Electrical Parts” (p.121). Then replace the part, if necessary.

3.3.3.2Fuser Area Jam / Paper Eject Area Jam

† Detection Timing

Table 3-24.Fuser Area Jam / Paper Eject Area Jam

Category	Explanation
Remaining paper	The light to the Paper Eject Sensor was transmitted at turning on of
	the Main Switch, at opening and closing of the front door, at
detection in fuser area
	occurrence of a paper jam or at stop of paper transport.
	The light to the Paper Eject Sensor was transmitted earlier than the
	passage of the predetermined period of time from the turning on of
Paper eject area	the Paper Feed Sensor.
	The light to the Paper Eject Sensor was not transmitted even after
	the passage of the predetermined period of time from the turning on
	of the Paper Feed Sensor.
	The light to the Paper Eject Sensor was intercepted earlier than the
Paper eject area jam	passage of the predetermined period of time from the turning off of
	the Paper Feed Sensor.

†Solution: Check the “Initial Check Items” (p.116) first and then replace the following components in the order named with new ones and repeat checking.

1.Paper Feed Sensor (S1)

2.Eject Sensor (PS3)

3.Main Board Assy (C533/C534 Main) (p.146)

CHECK	Before replacing any electrical part, check to see if the part in
POINT	question is defective or not by consulting “3.5 Troubleshooting for
	Electrical Parts” (p.121). Then replace the part, if necessary.

Troubleshooting Troubleshooting for Paper Jam 117