Transporting the Printer

If you need to transport your printer, follow these steps:

1.Press the Pause button and turn off the printer.

2.Open the printer cover and make sure that the print head is locked in the far right position. If it isn’t, turn on the printer, wait about 10 seconds, and turn it off.

Caution:

c Do not remove the ink cartridges when transporting the printer. Transporting the printer without the cartridges installed can damage the printer.

3.Unplug the power cord from the electrical outlet.

4.Disconnect the interface cable from the printer.

5.Remove any paper from the sheet feeder and remove the paper support.

6.Push in the output tray extension and close the tray.

7.Install the transportation screw to secure the print head to the carriage as described in the sticker above the print head.

8.Attach any other protective materials to the printer. See the Notice Sheet that was packed with the printer.

9.Repack the printer and attachments in the original box.

Be sure to keep the printer flat as you transport it. If you notice problems with your printed output after transporting the printer, clean the print heads as described on page 3-2. If the image is misaligned, calibrate the printer as described in your Setup and Software Guide or as described below, if you are printing from DOS.

Maintenance 3-9