Cable Box Unscrambles Only Some of Your Channels

If your cable box unscrambles signals for only some of your channels, connect it as follows:

1Connect the cable coming into the house to the ANT 1 connector on the back of the TV.

2Remove the jumper cable connected to both the RF Output and ANT 2 connectors on the back of the TV. Retain the cable.

3Connect one end of a coaxial cable to the RF Output connector on the back of the TV.

4Connect the other end of the coaxial cable to the IN connector on the cable box.

If your coaxial cable has a screw-type connector on the end, secure it by turning the end clockwise.

5Connect another coaxial cable to the OUT connector on the cable box.

6Connect the other end of the coaxial cable to the ANT 2 connector on the back of the TV.

7Be sure to turn on use of the TV’s ANT 2 port, as described on page 39.

Wall jack

Coaxial cables

Cable box

Note

Be sure to retain the jumper cable in case you change your TV connections later.

You’ll need to connect it again in certain connection schemes to provide the channel zapping feature.

Setting Up the TV 17