
Adjusting the tear-off position
If your paper’s perforation is not aligned with the
Follow these steps to adjust the
1.Make sure the Tear Off (Font) lights are flashing (the paper is at the current
2.Open the printer cover.
3.Hold down the Pause button for about three seconds. The printer beeps and the Pause light begins to flash as the printer enters Micro Adjust mode.
4.Press the LF/FF D button to feed the paper backward, or press the Load/Eject U button to feed the paper forward, until the paper perforation is aligned with the
Note:
The printer has a minimum and a maximum
5.After you set the
6.Tear off the printed pages.
26Paper Handling