Epson LX-300+II Selecting a Built-inFont

Selecting a Built-in Font

It is best to use your application program to select the font you want to use in a document. However, you may sometimes need to select one of the printer’s six built-in fonts using the buttons on the control panel, as described below. (The settings you make in application programs usually override settings you make from the printer’s control panel.)

❏ Draft		❏ Draft Condensed
❏	Roman	❏	Roman Condensed
❏	Sans Serif	❏	Sans Serif Condensed

Follow these steps to use the control panel to select a built-in font:

1.Make sure that the printer is on but not printing.

2.Hold down the Pause button for three seconds to enter

Micro Adjust mode. The Pause light begins to flash and the two Tear Off (Font) lights show the current font selection.

3.Press the Tear Off (Font) button repeatedly to cycle through the fonts, and stop when the lights on the control panel indicate the font you want. Your selection stays in effect until you change it again.

Using the Control Panel

35

Contents

Page Page Contents Introduction 1 Setting Up the Printer 2 Paper Handling 3 Using the Control Panel 4 Troubleshooting Purchase supplies and accessories 5 Product Information Introduction Options Page Setting Up the Printer Unpacking the Printer Choosing a Place for the Printer Assembling the Printer Page Page Connecting the Printer USB IEEE1284 (Parallel) RS-232C(Serial) Note: 12Setting Up the Printer Installing the Printer Software For DOS programs Viewing the On-screen Reference Guide Paper Handling Printing on Continuous Paper Printing with the push tractor Page Page Removing a printed document from the push tractor Switching between continuous paper and single sheets Printing with the pull tractor Page Page Adjusting the top-of-formposition LF/FF D Load/Eject U The printer has a minimum and a maximum After you set the Your Advancing paper to the tear-offedge Using the Tear Off button Advancing paper to the tear-offposition automatically Adjusting the tear-offposition Printing on Single Sheets Page Printing on Special Paper Adjusting the paper thickness lever Multipart forms Labels Envelopes Page Using the Control Panel Buttons and Lights 1 Tear Off (Font) lights 2 Tear Off (Font) button 3 LF/FF button 4 Load/Eject button 5 Pause button 6 Paper Out light 7 Pause light Selecting a Built-inFont Changing the Printer’s Default Settings Using Default Setting mode Restoring the printer’s default settings Page Troubleshooting Using the Error Indicators 40Troubleshooting Clearing a Paper Jam Printing a Self Test Page Where To Get Help Internet support Speak to a support representative Purchase supplies and accessories Page Product Information Safety Information Hot Parts Caution Symbol Important Safety Instructions FCC Compliance Statement for United States Users WARNING For Canadian users Declaration of Conformity Epson America, Inc., Limited Warranty What Epson Will Do To Correct Problems: What This Warranty Does Not Cover: