Manuals / Brands / Computer Equipment / Printer / Epson / Computer Equipment / Printer

Epson LX-300+II Using Default Setting mode, Restoring the printer’s default settings

1 50

Download 50 pages, 954.01 Kb

Using Default Setting mode

Follow the steps below to enter Default Setting mode. If you use single sheets, you’ll need to load a new sheet of paper each time the printer ejects a printed page.

1.Make sure paper is loaded and the printer is off.

2.Hold down the Tear Off (Font) button and then turn on the printer.

The printer enters Default Setting mode and prints instructions for selecting the language. The current language is indicated by which control panel lights are on. (For English, only the Pause light is on.)

3.If you want a different language, press the LF/FF button until the lights show the language you want.

4.Press the Tear Off (Font) button to print a list of all the current settings.

5.If the settings are all correct, turn off the printer to exit Default Setting mode.

If you want to change any settings, go to step 6.

6.Press the Tear Off (Font) button. The printer prints instructions for changing the settings.

7.Press the LF/FF button to scroll through the options for the selected setting until you see the one you want. Then press the Tear Off (Font) button to select the next setting you want to change.

8.When you finish making settings, turn off the printer to exit Default Setting mode.

Your new settings remain in effect until you change them again or reset the printer’s defaults.

Restoring the printer’s default settings

If you want to restore all the factory default settings, turn off the printer. Then hold down the Load/Eject, LF/FF, and Pause buttons while you turn on the printer.

Using the Control Panel

37

Contents

Page Page Contents Introduction 1 Setting Up the Printer 2 Paper Handling 3 Using the Control Panel 4 Troubleshooting Purchase supplies and accessories 5 Product Information Introduction Options Page Setting Up the Printer Unpacking the Printer Choosing a Place for the Printer Assembling the Printer Page Page Connecting the Printer USB IEEE1284 (Parallel) RS-232C(Serial) Note: 12Setting Up the Printer Installing the Printer Software For DOS programs Viewing the On-screen Reference Guide Paper Handling Printing on Continuous Paper Printing with the push tractor Page Page Removing a printed document from the push tractor Switching between continuous paper and single sheets Printing with the pull tractor Page Page Adjusting the top-of-formposition LF/FF D Load/Eject U The printer has a minimum and a maximum After you set the Your Advancing paper to the tear-offedge Using the Tear Off button Advancing paper to the tear-offposition automatically Adjusting the tear-offposition Printing on Single Sheets Page Printing on Special Paper Adjusting the paper thickness lever Multipart forms Labels Envelopes Page Using the Control Panel Buttons and Lights 1 Tear Off (Font) lights 2 Tear Off (Font) button 3 LF/FF button 4 Load/Eject button 5 Pause button 6 Paper Out light 7 Pause light Selecting a Built-inFont Changing the Printer’s Default Settings Using Default Setting mode Restoring the printer’s default settings Page Troubleshooting Using the Error Indicators 40Troubleshooting Clearing a Paper Jam Printing a Self Test Page Where To Get Help Internet support Speak to a support representative Purchase supplies and accessories Page Product Information Safety Information Hot Parts Caution Symbol Important Safety Instructions FCC Compliance Statement for United States Users WARNING For Canadian users Declaration of Conformity Epson America, Inc., Limited Warranty What Epson Will Do To Correct Problems: What This Warranty Does Not Cover: