5. Separator Installation

The separator of the Printer contributes to smooth paper feeding. Set the separator by inserting its edge into the two holes located at the rear part of the frame of the printer mechanism. (See Fig. 11)

Paper

Fig. 11 Separator installation6. Paper Loading6.1. Loading of fanfold paper

The MX-82 Printer accommodates fanfold paper from 4” to 10” in width. To load the fanfold paper, observe the following procedure.

STEP 1. Raise the printer lid.

2.Turn the scale toward the front of the Printer and detach it from the platen.

3.Confirm that the paper guide roller is at the center of the sprocket shaft. If not, set it at the center of the shaft.

NOTE: The paper guide roller contributes to smooth paper feeding.

4.Raise the two paper holding covers, and be sure to insert the fanfold paper between the frame and plastic roller of the separator. (See Fig. 12)

- 1 0 -