INSTALLATION OF MX-82

1. Unpacking

Before removing the MX-82 from the carton, check the box for evidence of shipping damage or mishandling. If such evidence is present, notify the carrier immediately.

1.1 Unpacking steps

Unpacking steps are as follows:

STEP 1. Open the carton.

2.Remove accessories.

3.Remove the MX-82 holding its underside and lifting it straight up with the packing materials attached.

4.Place the Printer with the packing material on a table or any other conven- ient flat surface.

5.Take off the packing materials carefully.

6.Remove the vinyl cover.

1.2Repacking steps

Repacking can be carried out by following the above steps in the reverse order. (Re- packing: Shipment for repair, storage, etc.)

NOTE: It is recommended that all original packing materials be saved for reuse in case the MX-82 requires reshipment in the future.

2. Counting Parts

The MX-82 and standard accessories are as shown in Fig.2. Upon unpacking, if you notice any listed contents missing or evident damage, contact the store where you purchased the MX-82 as soon as possible.

- 3 -