To remove the fanfold paper, follow either of the two methods described below.
(1)To disengage the paper from the paper holding mechanism, pull it forward out of the Printer.
NOTE: Do not attempt to pull out the paper in the backward direction.
(2)Feed the paper out of the printer by electrical operation. For this, turn the Power Switch on and push the Line Feed button. (Details are described later.)
6.3 Column layout on fanfold paperWhen fanfold paper of from 4” to 10” in width is supplied with the
The term “Top of Form position” is defined as the position in which the first print line lies on the form, and this position is determined when the power switch is turned on. Namely, adjust the paper position by the manual paper feed knob so that the required line position (i.e., the point at which the first line of the form is desired to be printed) is at the print head level. If, at this point, power is applied to the printer, this line position automatically becomes the Top of Form position.
When printing forms, the matchmarks located on both the sprockets facilitate the setting of the Top of Form position on the fanfold paper. To set the Top of Form po- sition, first enter (or preprint) a mark at a position on the edge of the paper 77 mm above the first print line position of the paper, then align this mark with the match- marks on the sprockets by turning the manual paper feed knob. At this point, turn the Power Switch on and the Printer will recognize this position as the Top of Form position. Now, the printing can be started from the Top of Form position.
In case of feeding one page of fanfold paper by operating the
- 1 4 -