If you want to format the disk after receiving this error message, do the following:
1.If the drive is not formatted, run the Unconditional format (option 2) and enter any tracks you know are bad in the Bad Track Table. (See “Unconditional Format” below.)
2.Run the Destructive surface analysis (option 3) to flag any remaining bad tracks. (See “Destructive Surface Analysis,” below.)
3.Run the Conditional format again. No errors should occur; if one does, contact your dealer.
Unconditional Format
Use this option to format your hard disk when you want to enter the list of bad tracks before formatting. The main difference between unconditional and conditional formatting is the way in which bad tracks are identified. With the unconditional format, you must enter the list of bad tracks before formatting begins.
To start the Unconditional format routine, press 2 and then Enter.
You are first given the option to change the interleave factor for formatting from the default value of three. Only do this if the documentation with your hard disk recommends a different value. You see this prompt:
Do you want default interleave of 3 (Y/N)?
To accept the default, press Y and Enter. To change the value, press N and Enter. You see this prompt:
Enter interleave factor
Type the recommended value, and press Enter.
Formatting a |