Problem Solver 205
Auto Take-up Reel Unit is
disconnected. Do you
continue?
The auto take-up reel unit is not connected. After reconnecting the
cable connecting the auto take-up reel unit to the printer, select No to
turn the printer off. Turn the printer on again after a short pause.
See the Setup Guide supplied with the optional auto take-up reel unit.
To continue printing without using the auto take-up reel unit, select
Yes.
Take-Up Error
Is anything obstructing the
take-up reel sensor system?
After checking the take-up reel unit sensor and removing any
obstructions, press the OK button.
If there is loose paper around the take-up reel unit roll core, set the
Auto switch to Off and keep the Manual pressed in the take-up
direction to remove the slack. After confirming that the paper is
correctly attached, return the Auto switch to its original position and
press the OK button.
See “Using the Auto Take-up Reel Unit (SureColor T7000 Only)” on page
61.
HDD Error
HDD used for another
printer needs to be
formatted. Continue?
Optional hard disk units that have been installed on other devices must
be formatted after being transferred to this printer. The disk cannot be
used until it is formatted. To format the disk, use the Setup menu in the
control panel.
See “Setup menu” on page 175.
Storage Error
Check if hard disk unit is
correctly installed.
Press the W button and select Job Cancel to stop printing. Remove
and reinstall the hard disk unit.
If this message appears on the LCD panel again, contact your dealer
or Epson Support.
To print regardless of hard disk status, select the Advanced tab in the
printer driver, open the Settings dialog of Hard Disk Unit, and select
Print only.
Paper Cut Error
Remove uncut paper. After pressing the OK button, pull out the paper and cut along the line
of the failed cut using scissors or a third-party cutter.
Align the end of the paper with all the poster board supports and press
the OK button.
Data Size Error
Data size of print job is too
large.
Check on print job.
The optional hard disk unit can store print jobs up to 100 GB in size. To
print larger jobs, select the Advanced tab in the printer driver, open
the Settings dialog of Hard Disk Unit, and select Print only; alternatively,
ensure that print jobs are less than 100 GB in size.
HDD Store Error
Hard disk does not have
enough space.
See documentation for
how to delete stored print
jobs.
Unwanted jobs can be deleted from Remote Manager or the LFP HDD
Utility.
See “Using the Optional Hard Disk Unit” on page 87.
HDD Boot Error
Hard disk error. Hard disk
cannot be used.
Press the OK button to clear the error from the control panel. To
continue printing regardless of hard disk status, select Print Only for
Hard Disk Unit Settings in the printer driver.
If this message appears on the LCD panel again, contact your dealer
or Epson Support.
Message What to do