Problem Solver 206
Copy Error
Cannot start copy with this
printer setting.
Refer to manual for details.
The printer will be unable to determine the size of the current paper
and make enlarged copies when Off is selected for Paper Size Check
in the Setup menu. Select On for Paper Size Check in the Setup menu.
See “Setup menu” on page 175.
Scanner Error
Refer to scanner manual for
details.
ORelease the scanner transportation lock and turn the printer and
scanner off and then on again.
OTurn the devices on and off several times. The scanner can be used
when the message is no longer displayed.
If this message appears on the LCD panel again, contact your dealer
or Epson Support.
Held Jobs Limit
Held jobs queue full. The number of held jobs has reached 200.
Press the OK button and select Resume All Jobs.
See “Using the Optional Hard Disk Unit” on page 87.
Paper Size Error
Loaded paper is not
supported size.
The loaded paper width is not supported. Press the OK button and
remove the paper.
Paper for use in the printer must be at least 10 inches (254 mm) wide.
Use paper that is at least 10 inches (254 mm) wide.
Should this message be displayed with paper of a width that can be
used in the printer, you may be able to print if you select Off for Paper
Size Check in the Setup menu.
See “Setup menu” on page 175.
Paper Sensor Error
Loaded paper or printout
has a problem.
Refer to the manual for
details.
Press the W button to clear the error from the control panel.
If this error is displayed when performing automatic head alignment,
check the following items.
ODoes the paper support auto head alignment?
Head alignment is not available with transparent or colored
media, tracing paper, paper not supported by the auto head
alignment function, or paper that is more than 1.0 mm thick.
See “Epson Special Media Table” on page 224 for information on
the types of paper that support auto head alignment.
OIs the printer exposed to a light source that interferes with auto
head alignment?
Shade the printer from direct sunlight or other light sources that
cause optical interference.
OAre the default values selected for both Platen Gap and Less Head
Scuffing?
Restore both items to their default values.
OAre some print head nozzles clogged?
Perform head cleaning. See “Cleaning the print head” on page
187.
If this error is displayed in circumstances other than those listed above,
check that the printer supports the current paper.
Message What to do