An | 32 |
|
If the projector experiences a problem or enters a status requiring attention, an
If there is more than one problem, warning, or status, the corresponding messages are output to separate lines.
Item | Details shown |
[Display name displayed in "Grouping view" or | |
| "Detail list view"] Projector status notification |
|
|
Body | <Display name displayed in "Grouping view" |
| or "Detail list view"> has entered the following |
| status. |
| <Problem/warning/status message (Please see |
| the table below)> |
|
|
The details contained in the
MessageRemedy
Internal Error | See your User’s Guide for more information. |
Fan error
Sensor error
Lamp Cover Open
Lamp failure at power on
Lamp Error
High internal temperature error
Low air flow error
Air filter air flow sensor error
Message | Remedy |
See your User’s Guide for more information. | |
warning |
|
|
|
Replace Lamp |
|
|
|
Replace Air Filter |
|
|
|
No Air Filter |
|
|
|
Low Air Flow |
|
|
|
Air Flow Sensor Err. |
|
|
|
Clean Air Filter Notice |
|
|
|
No signal | No image signals are being received by the |
| projector. Check the connection status and |
| check that the power for the connected |
| equipment is turned on. |
|
|
Other error | Stop using the projector, disconnect the |
Supply System Error | power cable from the electrical outlet, and |
(Ballast) | contact Epson. |
Auto Iris Error |
|
|
|
Network error (TCP | Check that the projector's power is turned on |
connection error) | and the LAN cable is connected, and also |
| check that "Network Monitoring" is set to |
| "ON" or "Standby Mode" is set to "Network |
| ON". |
|
|
Network error (ESC/ | Check that the projector has been correctly |
VP.net communication | connected to the network. |
error) |
|
|
|
Network error (monitor | Check the projector's Monitor Password. |
password authentication |
|
error) |
|
|
|
Messages to inform that the projector has recovered from the error or warning statuses are sent.