R290 User’s Guide
character space. The digits that you add after the PAUSE will be transmitted as DTMF tones across the network. For example:
You can send the number in the usual manner, or store, dial or edit it, or clear the number from the display. You can also recall the number from the phone book stores.
If you dial the number, when the DTMF tones are signalled over the network they are echoed through the earpiece so that you can hear what is happening. You can terminate the call as normal.
You may enter any number of PAUSES into a number. The number must not exceed 61 characters including the international prefix.
Sending DTMF Tones During a Call
You can generate DTMF tones manually while a call is in progress. This facility can be enabled/disabled from the Call
5 followed by YES. The display will be:
To enable the DTMF tones press 1 or YES. To disable them, press 2. A confirmation message will be displayed before the phone returns to the Call Setup Menu.
If the DTMF tones have been disabled and you need to send DTMF tones during a call, you can enable them using the
When enabled, any numerical key press, including <* and #>, will cause DTMF tones to be signalled across the network.
One-Touch Dialling
You can use the
Call Duration and Cost
The Call Time Menu sets the phone to record approximate call time and cost.
Last Call
1. Press SOFT LEFT, 2, to enter the Call Time Menu.
2.Press 1 or YES to display the duration and cost of the last call made. The time is displayed in hours, minutes and seconds. The cost is displayed in the chosen currency.
NOTE:
The cost is only displayed if the call rate charges (unit cost) have been entered into the phone, see “Call Cost Setup” on page 27. If you have set the call charging parameters to zero, only the duration of the call will be displayed.
26
