Operation
The PTO
Important: Operator must be in seat before the PTO can be engaged.
1.Set the throttle midway between the “SLOW” and “FAST” positions.
2.Pull the PTO switch outward to engage the blades.
3.Place the throttle in the “FAST” position to begin mowing.
Disengaging the PTO
1.Set the throttle midway between the “SLOW” and “FAST” positions.
2.Push the PTO switch in to disengage the blades.
Important: To begin movement (forward or backward) the operator must be in the seat, the brake lever must be disengaged (pushed down) before the motion control levers can be moved in or the engine will stop.
When the motion control levers are positioned fully outward (apart) in the
When the motion control levers are moved directly inward (together) the drive system is in the neutral operate position.
Stopping the Engine
1.Bring the unit to a full stop.
2.Move the motion control levers out to the neutral lock position.
3.Engage the parking brake.
4.Place the throttle midway between the “SLOW” and “FAST” positions.
5.Disengage the PTO.
6.Allow the engine to run for a minimum of 15 seconds, then turn the ignition switch to the “OFF” position to stop the engine.
7.Remove the key to prevent children or other unauthorized persons from starting engine.
8.Close the fuel
Driving the Machine
CAUTION
Machine can spin very rapidly by positioning one lever too much ahead of the other. Operator may lose control of the machine, which may cause damage to the machine or injury.
•Use caution when making turns.
•Slow the machine down before making sharp turns.
Figure 13
1. | Neutral lock position | 4. | Forward |
| (handles out) |
|
|
2. | Neutral operate position | 5. | Neutral (operate) |
| (handles in) |
|
|
3. | Front of Unit | 6. | Reverse |
|
|
|
|
Driving Forward
1.Release the parking brake.
2.Move the motion control levers inward to the center to the neutral position.
3.To move forward in a straight line, move both levers forward with equal pressure.
23
