Operation
Switch must be pulled out (up) to engage the blades. Switch is pushed in to disengage the blades.
Deck Lift Pedal
Located at the right front corner of the floor pan.
Push the pedal forward with your foot to raise the cutting deck. Allow the pedal to move rearward to lower the cutting deck to the cut height that has been set.
Figure 10
1. | Transport lock handle | 3. | Height of cut decal |
2. | Height adjustment pin | 4. | Deck foot pedal |
|
|
|
|
Transport Lock
Located on the height of cut adjustment plate (see Figure 10).
The transport latching mechanism will automatically engage when the deck is raised to the transport position. To release the deck from the transport position: push the foot pedal to remove the load from the transport latching mechanism, pull the transport lock handle rearward, and let the pedal come back to lower the deck down to the desired cut height.
Pre-Start
Fill fuel tanks. See Fuel Recommendations in the Specifications section for additional gasoline information.
Do Not add oil to gasoline.
Do Not overfill fuel tank. Fill the fuel tank to the bottom of the filler neck. The empty space in the tank allows gasoline to expand. Overfilling may result in fuel leakage or damage to the engine or emission system.
Make sure you understand the controls, their locations, their functions, and their safety requirements.
Refer to the Maintenance section and perform all the necessary inspection and maintenance steps.
Operating Instructions
Raise the Rollover Protection System (ROPS)
Important: The roll bar is an integral and effective safety device. Keep the roll bar in the raised and locked position when operating the mower. Lower the roll bar temporarily only when absolutely necessary.
1.The knob must be completely latched with the tabs interlocking as shown in Figure 11 to lock the roll bar in the raised, operate position.
2.Apply forward pressure to the upper hoop of the roll bar.
3.Pull the knob and rotate 90° to hold in the unlatched position to lower the roll bar.
4.To return to the operate position, raise the roll bar, and then rotate knobs 90° so that the tabs interlock partially. Apply forward pressure to the roll bar upper hoop and observe that the knobs return to the completely latched position.
21
