b)Check to be sure idler arms pivot freely, if not, lubricate idler pivots.
c)Check for worn drive belts.
NOTE: Wheel drive belts should be replaced as a set. A new belt should not be mixed with a worn belt.
d)Check drive linkage adjustment - See Section 4.1.5.
e)Check for proper tire pressure in drive tires. Recommended tire pressure for the drive tires is 12 to 16 psi (82
Note: Different pressures may make mower cut unevenly.
6.2MOWER CUTS UNEVENLY.
a)Check the drive tire pressure and tire circumference. See Section 4.1.9.
A more uniform cutting height may be obtained with higher tire pressure on rough terrain. A lower tire pressure provides more flotation.
b)Check blade spacers, axle positions, and front caster spacers. They must be equal on each blade.
c)Check caster mounting brackets to be sure all bolts are tight.
d)Check blades tip to tip for straightness. (They should be within 3/16" (.47 cm) or one blade width from being in line.)
6.3BLADES DO NOT STOP WHEN DISENGAGED.
a)Check the blade brake adjustment. (See Section 4.2.6)
b)Check the belt guide under the rear deck to make it is properly set (See Section 5.2.7) and check the PTO engagement adjustment. (See Section 4.2.5)
6.4ENGINE WILL NOT START.
a)Refer to Section 4.3.2 and follow directions to make sure engine is being properly choked.
b)Make sure transmission is in "true neutral" position. See Sections 3.12 (c).
c)Check that the PTO is disengaged and the PTO switch is depressed (See Section 4.2.12).
d)Check that there is fuel in the tank and that the fuel valve is open.
e)Check that the spark plug wire(s) is/are properly connected.
f)Check for loose or faulty wiring connections.
g)Check for corrosion at all wiring connections. Even minor corrosion may cause a faulty connection. Clean connector terminals thoroughly, apply dielectric grease and reconnect.
h)For Kawasaki: Check that the key switch is in the “Run” position.
NOTE: After carefully checking the previous steps, attempt to start the engine. If it does not start, contact your authorized Exmark service dealer.
ENGINE TROUBLESHOOTING
When a problem occurs, do not overlook the simple causes. For example, starting problems could be caused by an empty fuel tank, key switch not "ON" etc. The following tables list some common causes of troubles. Do not attempt to service or replace major items or any items that call for special timing or adjustment procedures (governor, valves, etc.). Have this work done by your Engine Service Dealer.
- 31 -
