LUBRICATION CHART
FITTING LOCATIONS | INITIAL | ||
PUMPS | |||
|
| ||
1. | Caster Wheel Bearings | 12 | |
2. | Caster Pivots | 2 | |
3. | Drive Wheels | 18 | |
4. | Drive Wheel Idler Arm | 2 | |
5. | Brake Arm | 2 | |
6. | Trans. Output Shaft Coupler | 2 | |
7. | Mower Deck Idler Pivots | 2 | |
FITTING QUANTITY | SERVICE | ||
32" | 36" | 48" | INTERVAL |
2 | 2 | 2 | Daily |
2 | 2 | 2 | Daily |
2 | 2 | 2 | Daily |
2 | 2 | 2 | Daily |
2 | 2 | 2 | Weekly |
2 | 2 | 2 | Weekly |
1 | 1 | 1 | Weekly |
No.6 (Trans. Coupler)
Located Below
Fuel Tank Support
No. 4 & 7 (Idler Arm Pivots)
Disassemble and grease once a
Month under a “No Load” condition
48” Deck Shown for Reference Only
c)Replace
d)Lubricate pivot points with a spray penetrating lubricant as directed below.
SPRAY LUBRICANT CHART
PIVOT POINTS | NO. of PLACES | SERVICE INTERVAL | |||
32" | 36" | 48" | |||
|
| ||||
1. Blade Engagement Bellcrank | 1 | 1 | 1 | Weekly | |
4.1.13Remove engine shrouds and clean cooling fins.
Service Interval: See Engine Owner's Manual
a)Stop engine and wait for all moving parts to stop. Remove key or spark plug wire(s).
b)Remove cooling shrouds from engine and clean cooling fins. Also clean dust, dirt and oil from external surfaces of engine that can cause improper cooling.
c)Make sure cooling shrouds are properly reinstalled. Operating the engine without cooling shrouds will cause engine damage due to overheating.
4.1.14Check spark plugs.
Service Interval: See Engine Owner's Manual
Remove spark plug, check condition and adjust plug gap, or replace with new plug (See Engine Owner’s Manual).
4.1.15Change fuel filter.
Service Interval: As Required
A fuel filter is installed in the fuel line between the fuel tank and the engine. Replace when necessary.
4.1.16Engine maintenance.
Service Interval: See Engine Owner's Manual
Refer to the Engine Owner's Manual regarding maintenance required for the engine.
4.1.17Check all safety signs for visibility. Replace as needed.
-23 -
