Extreme Networks 8800 Series Inserting the Option Card, Installing an Option Card in the MSM-48c

Installing an Option Card in the MSM-48c

Figure 74: Inserting the Option Card

Option card

MSM48c_hsp-latch

6Release the hot-swap prevention latch and verify that the option card has engaged the alignment pins and connector at the back of the card.

7At the back of the option card, align and finger-tighten the captive retaining screws to secure the card in place (Figure 75).

Figure 75: Securing the Option Card

Tighten retaining screws

Option card

MSM48cOptionCarda

8Re-install the MSM-48c, following the instructions in “Installing a BlackDiamond 8800 Series Module” on page 102.

Leave the ESD-preventive wrist strap permanently connected to the switch so that it is always available when you need to touch ESD-sensitive components.

BlackDiamond 8800 Series Switches Hardware Installation Guide 123