![](/images/new-backgrounds/1189181/189181183x1.webp)
Installing Power Supply Units in the BlackDiamond 8800 Series Switches
Figure 51: Inserting an AC PSU into the Power Supply Bay
EX_174 |
4Secure the AC PSU in the power supply bay by pushing down on the locking handle until it clicks into place.
5If you are replacing a power supply, you do not need to unplug the AC power cord. For a newly installed power supply, connect the AC power supply cord:
a If necessary, remove the power cord retaining bracket as described in Chapter 3, “BlackDiamond AC Power Cord Retaining Brackets.”
b Connect the new AC power cord to the AC input on the front of the switch and to the wall outlet on the other end. Then
c
To install additional Extreme Networks AC PSUs, repeat steps 2 through 5.
NOTE
Leave the ESD strap permanently connected to the switch, so that the strap is always available when you need to handle
Removing or Replacing an Extreme Networks AC PSU
CAUTION
The AC PSU may be hot to the touch; use thermal protective gloves when handling the PSU during removal.
To remove or replace an Extreme Networks AC PSU:
1Attach an
92 | BlackDiamond 8800 Series Switches Hardware Installation Guide |
|
|