Extron electronic IN1403 Menu Commands

Menu Commands

The IN1402 allows you to manually adjust the bri ghtness, contrast, color, hue, sharpness, gamm a,

noise filter, and comb/trap filter settings.

To access the video adjustment menu via the front panel control buttons

1. Press the desired Input Select button.

2. Press MENU.

3. Press the or button (if necessary) to reach the video menu.

4. Press ENTER.

5. Use the and buttons and the ENTER key to select the setting you wish to adjust.

6. After selecting a setting, use the and buttons to make the adjustments.

7. Press and release a button to move one step in either direct ion.

8. Press and hold a button to move continuously through the adjustment range.

9. Press ENTER to save when the input is optimized.

CAUTION

It is critical that you save the setting before proceeding to another input or another menu

function, otherwise your new adjustment will be lost.

The following video adjustment parameters can be controlled via the on-screen menu system (front

panel buttons). Remote operation instructions can be found on page 19.

Brightness Setting adjusts the input signal brightness.

Range: 0 to 255

Factory default setting: 128

Operation:

Press button to increase the brightness.

Press button to decrease the brightness.

Contrast adjusts the difference between the input signal’s brightest and darkest settings. At the

minimum setting the screen picture displays at about the same brightness (very grayish). The

maximum setting displays a noticeable difference between the darkest and lightest parts of the screen

picture.

Range: 0 to 255

Factory default setting: 128

Operation:

Press button to increase t he contrast.

Press button to decrease the contrast.

Color adjusts the color saturation of the picture over a wide range. Setting this control to 0 removes

most of the color.

Range: 0 to 255

Factory default setting: 140

Operation:

Press button to increase the color.

Press button to decrease the color.