Output menu
To access the output menu via the front panel control buttons, do the following:
1.Press the desired Input Select button.
2. | Press MENU (press the or button to reach the output menu, if necessary). |
3. | Press ENTER. |
4. | Use the and buttons and the ENTER key to select the setting you wish to adjust. |
5. | Press ENTER to save once you’ve optimized the setting for the current input. |
Output Resolution:This controllets you select the appropriate resolution for your display device. The available resolutions are listed in the table under Output modes on page 18. Because the IN1403 only scales up, users must choose an output resolution that is greater than or equal to the input size. For instance, you may not select 640 x 480 output with PAL input signals since PAL has more than 480 lines of video.
Of all the settings on the IN1403, perhaps the most critical adjustment is the output resolution. Setting the scaler to match the capabilities of your data display device will have an enormous impact on the image quality. To achieve the optimum image on your display device, refer to the Choosing the Optimal Output Resolution and Refresh Rate section on page 15.
Refresh Rate: Allows you to choose the optimal refresh rate for your display device.
Not all resolution and refresh rate combinations are available. Refer to the chart on page 18 for a complete listing.
Size adjusts the output horizontal and vertical size. It shrinks the size to a percentage of the output resolution selected. The output size is automatically reset anytime a new input aspect ratio is selected. This setting is useful to manually reduce the height of the output signal when an anamorphic input signal is connected. The IN1403 only scales up; therefore the output size controls will stop at a certain point where the input and output resolution are equal.
Position situates the output image on the monitor. The output position is automatically reset anytime a new input aspect ratio is selected.
Sync Format: Select an output signal format that is compatible with your display.
RGBHV++: RGB with positive horizontal and vertical sync
RGBS A: RGB with composite sync (with serrations)
RGBS B: RGB with composite sync (without serrations)
RGsB A: RGB with sync on green (with serrations)
RGsB B : RGB with sync on green (without serrations)
Blue Screen: Available anytime (even when the input settings are incorrectly adjusted or the input signal is missing entirely), the blue screen may be used as a test signal to adjust the output settings (resolution, refresh rate, size, position and sync format) and verify the image on the monitor. The video and input settings have no effect on the blue screen. Once the output settings have been properly adjusted and verified on the monitor, the blue screen may be turned off to adjust the video and input settings.
Reset Output Settings: Resets all output settings to factory default.
Advanced menu
To access the advanced menu via the front panel control buttons, press the desired Input Select button,
press MENU, press the | or button (if necessary) to reach the advanced menu, then press ENTER. | |||
Use the | and | buttons and the ENTER key to select the setting you wish to adjust. Once you’ve | ||
14 | ||||
optimized the setting for the current input, press ENTER to save.
