Extron electronic MPS 601 manual Installation, Mounting the Switcher, Connections

Installation

This section describes the installation and the operation of the MPS 601, including:

•Mounting the Switcher

•Connections

•Contact Closure and Tally Output Application Diagrams

•Lockit Lacing Brackets

•Cabling the MPS 601 Switcher

Mounting the Switcher

The MPS 601 is housed in a 1U, full rack width rack- or desk-mountable metal enclosure. The switcher can also be surface‑mounted under a table, desk, or podium, or on a wall.

See Mounting Options on page 44 for additional mounting details.

Connections

	A	B	C		D	E		F		G
MPS 601		1	A	INPUTS		OUTPUT
				3	5	HDMI
POWER							C G T	C G T	C G T	+V
							1	3	5
	12V	RGBHV					CONTACT IN / TALLY OUT			REMOTE
0.5 A MAX
		2		4 HDMI	6 HDMI
			B				2	4	6	RS-232
							C G T C G T C G T Tx Rx G

H

Figure 2. MPS 601 Rear Panel

Power and Input Connections	Output Connection
A DC power connector.	E One female HDMI connector.

BTwo Configurable analog 15-pin HD (VGA) connectors.

CTwo female 3.5 mm TRS connectors (lettered A and B on the rear panel) corresponding to the two RGBHV video inputs.

DFour female HDMI connectors for HDMI compliant audio and video input (numbered 3, 4, 5, and 6 on the rear panel).

Control Device Connections

FContact In/Tally Out — Six

3.5 mm, 3-pole captive screw connectors for automatic input switching and tally indication using Extron Show Me cables.

G+V Port — 3-pole 3.5 mm captive screw connector for +V output.

HRS-232— 3-pole, 3.5 mm captive screw connector.

MPS 601 • Installation 4