![](/images/new-backgrounds/1109241/10924129x1.webp)
Lockit Lacing Brackets
The included Lockit lacing brackets secure the HDMI cables to the rear panel connectors as shown. The configuration of the HDMI connectors on the MPS 601 rear panel require using a top mount (HDMI output) and a stacked side mount (HDMI inputs 3 and 4 or inputs 5 and 6) installation to secure the four inputs and single output.
1.Loosen the HDMI connection mounting screw from the rear panel enough to allow the LockIt lacing bracket to be placed over it.
NOTE: Do not remove the screw.
2.Place the LockIt lacing bracket on the screw and against the HDMI connector, then tighten the screw to secure the bracket.
3.Plug the HDMI cable into the panel connection
4.Loosely place the included tie wrap around the HDMI connector and LockIt lacing bracket. Hold the connector securely against the lacing bracket and tighten the tie wrap, then remove any excess length.
3
4
2
1
3
2
3
3
4
Figure 11. Lockit Lacing Bracket Installation
A single LockIt bracket can be used to secure two HDMI connectors in a stacked configuration as shown below.
I HDM
3
3
Top | Side | Stacked |
Figure 12. Lockit Lacing Bracket Examples
MPS 601 • Installation | 9 |