Extron electronic MSG0808, MSG0804 manual Remote Control, cont’d, Command Table, Set-up commands

Remote Control, cont’d

Command Table

Set-up commands

	Use these commands to configure the switcher. If you are using a third-party
	control system, you should place these commands in the start-up section of the
	program. You only need to send these commands to the switcher once.
Command	Description
Request information
[ARC]	Request for model and version information.
Reset comm port
[CPx@]	Resets the communications port to the factory default (9600
	baud, 8-bit, 1 stop bit, no parity, and no flow control)
	• Where x = 1
Query comm port
[CPx?]	Query the communications port for current settings
	• Where x = 1
Configure comm port
[CPxbpsfd]	Configures the communications port for baud rate, flow
	control, and duplex
	• Where:
	x = 1
	b = 0 for 1200, 1 for 2400, 2 for 4800, 3 for 9600, 4 for
	19200, and 5 for 38400
	p = 0 (no parity)
	s = 0 (1 stop bit)
	f = 0 to disable flow control and 1 to enable flow control
	(xOn/xOff)
	d = 0 (full duplex) or 1 (half duplex)
	Default is 9600 baud, 1 stop bit, 8 data bits, no parity, no flow control, and full duplex
Factory reset
[DFLTx]	Performs a factory reset. The partial reset will return I/O
	configurations, volume levels, and serial set-up to factory
	levels. The full reset will return all parameters (including
	presets) to factory default levels.
	• Where:
	x = 0 for partial reset
	x = 1 for for full reset
Front panel executive mode
[FPx]	Enable or disable front panel executive mode and request
	current status.
	• Where:
	x = 0 to enable executive mode (no front panel operation)
	x = 1 to disable executive mode
	x = ? to request current state
	x = (blank) to toggle the current state
Serial response enable
[RESx]	Enable or disable serial responses from the switcher.
	• Where
	x = 0 to disable
	x = 1 to enable

5-4 MSG Matrix Switchers • Remote Control