Controls and Installation, cont’d
Cabling
The P/2 DA2 WM F cabling diagram below shows how to connect input and output devices to the distribution amplifier’s front panel. The P/2 DA2 WM EC F model has identical connectors.
AUTO POWER |
100% |
UNITY |
50% |
GAIN/PEAKING |
P/2 DA2 WM F cabling |
1.Connect your display device to the
2.For audio output, refer to the section “Connecting audio output” and connect the audio output cable to the 3.5 mm captive screw connector on the rear of the P/2 DA2 WM F/EC F.
3.Connect the power input cable to the rear power input connector of the P/2 DA2 WM F/EC F.
4.Connect the computer’s video cable to the
5.If a local monitor is being used, connect the monitor to the
6.For audio input, connect the input device into the front faceplate’s 3.5 mm female audio jack.
Connecting audio output
Before connecting audio output, determine whether your audio system is unbalanced or balanced. Then, follow the instructions below to connect unbalanced audio, or the instructions for “Balanced audio” to connect balanced audio.
CWiring the audio incorrectly may damage the audio output circuits.
Unbalanced audio
To attach the P/2 DA2 WM F/EC F to an unbalanced audio system, do the following:
1.Attach the audio cable to an unbalanced speaker input connector (tip and sleeve).
Tip (+)
Sleeve ()
2.Attach the audio cable to the audio cable connector (Extron part number
Fastening captive screws
CAUTION
For unbalanced audio, connect the sleeve(s) to the ground contact.
DO NOT connect the sleeve(s) to the negative
Tip | Left |
NO Ground Here | |
Sleeve(s) |
|
Tip | Right |
NO Ground Here |
|
Unbalanced Output
3.Slide the audio cable connector into the audio output connector on the interface.
P/2 DA2 WM/EC/D/AAP Series • Controls and Installation |