Falcon FN6KRM-2TXI, FN4KRM-2TXI, FN3KRM-2TXI manual How to Change the Programmed Settings

6.7 How to Change the Programmed Settings

Note: The UPS must be placed into Off / Bypass mode prior to attempting to change the following parameter settings.

1.To enter programming mode depress the “On” and “Next Page” buttons at the same time and hold them down until the UPS sounds two beeps. The audible alarm status parameter setting will be displayed.

The audible alarm parameter settings cannot be set in this programming mode. Refer to section 6 of this manual for setup instructions.

Depress the “Next Page” button.

Self-test parameter settings cannot be set in this programming mode. Refer to section 6 of this manual for setup instructions.

Depress the “Next Page” button and go to the next page.

27