Falcon FN6KRM-2TXI, FN4KRM-2 manual Operation, How to start up the UPS with utility power present

6.0 OPERATION

The following sections outline the operation and programming of the FN -2TXI UPS models. Please read and understand them completely prior to connecting any equipment to the UPS output.

6.1How to start up the UPS with utility power present

1.Verify the UPS input wiring is correct and connected to a live circuit.

2.Turn on the UPS and Bypass input circuit breakers located on the UPS rear panel, and the following LCD Display will be displayed. The UPS output will be immediately turned on, with the UPS in bypass mode.

Display A is an LCD test display and is shown for about 3 seconds after the input circuit breaker is turned on.

Next, display B is shown (OFF or BPS displayed). The UPS is OFF with the load supported by the bypass output. The UPS will remain in this state until the “On” button is depressed. When the UPS is turned off using the “Off” button, it will return to this state until the input circuit breaker is turned off.

3.Depress the “On” button for 3 seconds until two audible beeps are sounded.

4.The UPS fans will turn on and the following LCD display will be shown:

Note the MIMIC portion of the display with the arrow under the line and the input voltage is displayed.

The UPS will sound two short beeps continuously until the following is displayed.

NOTE: Always allow the UPS to charge its batteries for 8 hours prior to use.

5. The UPS will now sequence up to on-line mode and display the following:

The UPS initiates a self-test.

Go to the next page.

19