INSERTING DISHDRAWER INTO CAVITY
3.1.1
Position product to suit joinery ensuring hoses are not kinked or cut.
3.1.2
Insert M8 bolts and washers through holes in shelf.
3.1.3
Ensure product is correctly positioned and aligned before tightening.
Refer to Step 7.1 - Installation Wet
Test.
SECTION 3
WARNING
DO NOT push against the middle of the drawer.
IMPORTANT
Make sure the inlet and drain hose and main flex are not restricted or damaged by carefully pulling them through the Services Hole as the DishDrawer is being pushed back into the cavity.
WARNING
The DishDrawer should not support any part of the kitchen cabinetry.
