STEP 5.4 FITTING THE BADGE, HANDLE & MOUNTING PANEL TO THE DRAWER FRONT
5.4.1
Remove Drawer Front Mounting Panel by withdrawing pins from sides of drawers using long nosed pliers.
5.4.2
Slide Mounting Panel off in a downwards and outwards motion.
5.4.3
Using an Allen Key, screw in Mounting Bracket Nuts. Remove Burrs. Screw in flush with back surface.
5.4.4
Fit the Door Mounting Panels using the screws supplied.
5.4.5
Feed wires through to the back and press badge into hole. If needed, adhere badge to Drawer Front with a glue or silicon sealant.
5.4.6
Fit the customer supplied handle.
Refer to Step 4.1.3 - Control Badge
Position.
WARNING
Care should be taken in the following steps.
CAUTION
Take care not to damage front surface of panel.
Ensure all cuts are straight and care is taken to avoid damage to the Drawer Front.
CAUTION
Overtightening will damage the Drawer Front.
Page DS_16
I
N
T
E
G R A T E D
P
R
O D U C T
O N L Y
