Fisher & Paykel DS602I manual 5.5.1, 5.5.2, 5.5.3, 5.5.4, Step, View of Slide Hooks, Page DS17

I

N

T

E

G R A T E D

P

R

O D U C T

O N L Y

TIP

Use a small amount of liquid soap along the lip of the seal to aid the Drawer Front to slide on easily against the seal.

CAUTION

The rubber seal between the Drawer and Drawer Front must be kept in place.

WARNING

The Electronics Board is an electrostatic sensitive device. Ensure you are adequately grounded when connecting or disconnecting the badge by wearing a grounding strap or by grounding yourself to the DishDrawer.

WARNING

Ensure the product is not plugged in.

View of Slide Hooks

CORRECT 

INCORRECT 

Page DS_17

STEP 5.5	FITTING THE DRAWER FRONT TO THE DISHDRAWER
	5.5.1
	Fit seal to Drawer.

5.5.2

Plug the grounding wire into the panel.

Connect badge wires to integrated badge port on Electronics Board.

5.5.3

Fit Drawer Front by sliding in an upwards and inwards motion.

5.5.4

Ensure the slide hooks (on slide) are as far forward as possible as shown, then insert pins to lock in place, ensuring that the rib on the pin is vertical.

Check fit of the Drawer Front and adjust if required.