WARNING
Ensure the edges of the Service Hole are smooth or covered. (See Step 1.2 - Product Specifications & Cavity Dimensions.) If the Services Hole is through a metal partition, the hole must be protected with the Edge Protector provided.
WARNING
DO NOT adjust the length of the Inlet Hose.
TIP
Turn the water valve ON to check for any leaks, before pushing the DishDrawer back into its cavity.
STEP 2.2 CONNECTING THE SERVICES
2.2.1
Feed the Power Cord, Inlet Hose and Drain Hose through the Services Hole. Position the DishDrawer in front of the opening.
2.2.2
Connect the Inlet Hose to the HOT WATER SUPPLY. Ensure the sealing washer
supplied with the accessories is fitted.
Hose coupling must be tightened a further half turn after seal contact.
2.2.3
If required, the Drain Hose may be trimmed to a suitable length.
2.2.4
If an air break option is not chosen, then the Drain Hose Support must be used and positioned at least 133/4” (350mm) above the base of the DishDrawer to prevent siphoning of the water during the wash program. (See Step 1.4 - Electrical, Plumbing & Drainage Information.)
WARNING
Attach the Drain Hose Support to the cabinet cabinetry to prevent siphoning and to keep the Drain Hose from kinking.
2.2.5
When using a standpipe option, hose should not extend further than 2” (50mm) down the standpipe in order to prevent siphoning.
