2.2.6
If required, trim the Single Connector to the size which matches the waste tee or air break to be used. There are ribs provided to guide cutting.
When using the Single Connector, the hose should be pushed in firmly, 5 clicks.
Remember to slip the Wire Clip over the Drain Hose before connecting to the Single Connector.
The supplied Wire Clip should be installed between the two positioning ribs on the Single Connector.
2.2.7
Attach Single Connector to waste tee. Ensure snug fit using the supplied hose clamp.
Ensure there is a power outlet in reach of the supplied flex. If there is not a suitable outlet available then have one installed by a qualified electrician.
DO NOT modify the power plug supplied with the DishDrawer or use an extension cord, adaptor plug or multiple outlet box.
2.2.8
Alternatively, the DishDrawer may be permanently connected to flexible conduit.
Remove the flex and cable clamp. Fit suitable cable clamp for the conduit and terminate the wiring as shown.
Use the solderless lug and washer supplied with the product parts to terminate the ground wire.
WARNING
The Product MUST NOT be plugged in at this stage.
WARNING
