Fisher & Paykel OB30 manual Care and cleaning 31 US, Cleaning the porcelain enamel surfaces

Models: OB30

1 84
Download 84 pages 41.67 Kb
Page 33
Image 33
Care and cleaning 31 US

Care and cleaning 31 US

CA

Cleaning the porcelain enamel surfaces

The oven interior and inner door liners are porcelain enamel and are cleaned during the self- clean cycle.

Cleaning the sliding shelves

Important!

Never leave the sliding shelves in the oven during a self-clean cycle. If you do leave them in the oven, the slides will no longer run smoothly. If you need to relubricate the slides, wipe them with a few drops of cooking oil on a paper towel.

Apply chrome cleaners with a damp sponge or cloth following manufacturer directions. Wipe and dry. For hard-to-remove food soil, use a dampened soap-filled non-metal pad, wipe and dry. Do not wash the sliding shelves in the dishwasher. Do not immerse them in soapy water, or use oven cleaner on them. Removing the white lubricating grease will reduce the life of the shelf slides and prevent them from running smoothly.

Cleaning the broil/roast system and side racks

Clean these using a solution of detergent and hot water. They are also dishwasher safe.

Changing the oven light bulbs

The oven is illuminated by three 12 volt/20 watt halogen bulbs. These have a very long life, but if you should need to replace one, use only a replacement bulb purchased from your nearest Fisher & Paykel dealer and follow these steps:

1Allow the oven to cool completely and then turn it off at the wall.

2

Take out the shelves and side racks (see ‘Removing

 

 

 

 

 

and replacing the sliding shelves and side racks’)

 

 

 

 

 

 

and use a small flat-head screwdriver to twist

 

Retainer clip

 

and lift the retainer clip at the top of the glass

 

 

 

 

Plate glass cover

 

light cover while holding the glass to prevent it

 

 

 

 

 

 

 

 

 

falling. The clip pivots counterclockwise (see the

 

 

 

 

 

 

diagram).

 

 

 

 

 

3

Carefully lift the glass cover out of the lower

 

 

 

 

 

 

support and pull out the faulty bulb.

 

 

 

 

 

4

Holding the replacement bulb in a soft cloth or

 

 

Pins

 

tissue (touching the bulb will reduce its life span),

 

 

 

 

 

 

 

insert the new bulb.

Sockets for

 

 

5

Reposition the glass cover and twist the top clip

 

 

 

 

 

the pins

 

back in place. The procedure is the same for the

 

 

 

 

 

 

 

Replacement bulb

 

light in the roof of the oven cavity.

 

 

 

 

 

 

 

 

 

 

 

 

Note: oven bulb replacement is not covered by your warranty.

Page 33
Image 33
Fisher & Paykel OB30 manual Care and cleaning 31 US, Cleaning the porcelain enamel surfaces, Cleaning the sliding shelves