Fisher & Paykel OB30 Troubleshooting, Problem, Possible cause, What to do, Fault codes, 37US CA

Troubleshooting

Fault codes

37US CA

If there is a fault, the oven will beep every second, and a fault code will appear in the clock display as a letter ‘F’ with a number after it.

Important!

Do not turn off the mains power supply to the oven if you get a fault code. The fans are needed to cool the oven.

For safety, this oven is designed to self-cool. Turning off the power while the oven is hot may damage the oven and its surrounding cabinetry.

If you get a fault code:

1Note the fault code.

2Turn the temperature and function knobs to OFF.

3	Press the	PUSH TO	button. The oven may have already self-corrected, and this will be
		CLEAR
	enough to clear the fault.
4	Call your Fisher & Paykel Authorized Service Center with the fault code information.

Note: if your are unable to immediately clear the fault code or contact your Fisher & Paykel

Authorized Service Center, wait for the oven cooling fans to stop, and then press the PUSH TO

CLEAR

button again. It is likely that the oven will now clear the fault. If it does not, then you may turn the oven off at the wall once the fans have stopped and the oven has completely cooled down.

Troubleshooting

Problem Possible cause What to do

Oven does not work

Power supply is not	Have a service company/electrician
connected.	check power connections, wiring and
	fuses.
Clock is not set due to	You must set the clock before you can
power cut or failure.	use the oven. The oven will go into
	‘Set Up’ mode when the electricity
	is restored after a power cut. The
	function and temperature displays will
	be unlit and unresponsive. The colon
	(:) in the clock display will flash. See
	‘Setting the clock’.

Oven door is open.	The elements are disabled by the door
	switch when the door is open. Make
	sure the door is properly closed.