Fitness Quest 1175e manual Program Profiles, Attaching the Monitor, Installing the Handlebars

Program Profiles

PROGRAM 1		PROGRAM 5		PROGRAM 9
	MANUAL		RAMP		TARGET HEART RATE

PROGRAM 2		PROGRAM 6		PROGRAM 10
	ROTATING		FITNESS TEST		60% HEART RATE

PROGRAM 3		PROGRAM 7		PROGRAM 11
	VALLEY		INTERVALS		75% HEART RATE

STEP 7 – Attaching the Monitor

a)Remove the Bolts from the rear of the Monitor (see 7a).

b)Put the Wires from the rear of the Monitor into the large hole of the Monitor Plate. Then insert the Bolts through the Monitor Plate into the Monitor.

c)Connect the Monitor Wire to the Vertical Tube Wire.

d)Connect the Monitor Pulse Wires to the Vertical Tube Pulse Wires.

e)Insert the Monitor Plate into the Vertical Tube. Align the Bolt holes after inserting Monitor Mount (see 7b).

f)Insert and tighten two Phillips Bolts into the holes.

monitor

monitor

mount

7b

stationary bar

monitor

7a

monitor pulse wires

monitor wire

monitor plate

M5 x 10mm phillips bolt

vertical tube pulse wires

vertical tube wire

M5 x 16mm phillips bolt

PROGRAM 4	PROGRAM 8		PROGRAM 12
FAT BURN		BODY FAT PROGRAM		85% HEART RATE

Figure 7a & b – Install Monitor

16

STEP 8 – Installing the Handlebars

a)Connect the Vertical Tube Pulse Wire to the Left Handlebar Pulse Sensor Wire.

b)Install the Left Handlebar into the Left Swing Arm. Make sure to align the Bolt Holes of the Left Handlebar with the Bolt Holes of the Left Swing Arm.

c)From the rear of the Elliptical, insert the two Carriage Bolts through the two holes.

d)Install a Curved Washer, a Spring Washer, and then an Acorn Nut onto each Bolt. Make sure each Acorn Nut is tightened.

e)Connect the Vertical Tube Pulse Wire with the Right Handlebar Pulse Sensor Wire.

f)Install the Right Handlebar into the Right Swing Arm. Make sure to align the Bolt Holes of the Right Handlebar with the Bolt Holes of the Right Swing Arm.

g)From the rear of the Elliptical, insert the two Carriage Bolts through the two holes.

h)Install a Curved Washer, a Spring Washer, and then an Acorn Nut onto each Bolt. Make sure each Acorn Nut is tightened.

right

handlebar

left

handlebar

		REAR
FRONT
		pulse sensor wire
M8 acorn	M8 curved	vertical tube
	washer	pulse wire
nut
M8 spring
washer
pulse sensor		M8 x 50mm
		carriage bolt
wire

vertical tube

pulse wireright swing arm

left swing arm

Figure 8 – Install Handlebars

9