TROUBLESHOOTING GUIDE
PROBLEM |
| CAUSE |
| CORRECTION |
| ||
Treadmill will not start | 1. Not plugged in | 1. | Plug into three prong grounded outlet | ||||
| 2. | Not turned on | 2. | Turn on the Main Power, on/off button | |||
| 3. | Safety Key not on correctly | 3. | Put Safety Key on Console where | |||
|
|
|
| indicated | |||
| 4. | Circuit Breaker opened in home | 4. | Reset home breaker | |||
| 5. | Treadmill Circuit Breaker tripped | 5. | Reset Treadmill Circuit Breaker | |||
|
|
|
| (see below) | |||
|
|
|
|
|
| ||
Treadmill Speed Not Correct | 1. Treadmill starts at 0.5 calibrated | 1. | With Monitor powered off, press & hold the | ||||
|
| in miles – 0.8 calibrated in Kilometers |
| Select button for 4 sec. to adjust reading | |||
|
|
|
|
| |||
Treadmill Speed Surges | 1. Walking Belt slipping | 1. | Tighten Walking Belt (see page 13) | ||||
| 2. | Lubricate Walking Belt | 2. | Lubricate Belt and Deck (see page 14) | |||
| 3. | Motor Controller not set properly | 3. | Call | |||
|
|
|
|
|
| ||
Treadmill Belt will not move - | 1. Lost speed input signal | 1. | Call | ||||
ERR 1 on screen |
|
|
|
|
|
|
|
|
|
|
|
|
| ||
Incline will not operate - | 1. Lost incline signal | 1. | Remove and replace Safety Key and | ||||
ERR 3 on screen |
|
|
| Treadmill will recalibrate | |||
|
|
|
|
|
| ||
Treadmill Belt Slipping | 1. Walking Belt loose | 1. | Tighten Walking Belt (see page 13) | ||||
| 2. | Deck needs lubrication | 2. | Lubricate Belt and Deck (see page 14) | |||
|
|
|
|
|
| ||
Treadmill Noisy | 1. Loose hardware | 1. | Tighten all visible Screws, Nuts, and Bolts | ||||
| 2. | Motor straining | 2. | Check Belt tension - 3 finger test | |||
|
|
|
| (see page 13) | |||
| 3. | Clicking sound - Roller knocking | 3. | Adjust Rear Rollers - check for tension | |||
|
|
|
| (see page 13) | |||
|
|
|
|
|
| ||
Inaccurate pulse rate | 1. Too much hand movement | 1. | Stand on Side Rails to get accurate pulse | ||||
|
|
|
| reading | |||
| 2. | Palms too wet | 2. | Dry palms | |||
| 3. | Gripping hand grips too tight | 3. | Grip using moderate pressure | |||
| 4. | Wearing rings | 4. | Remove all rings | |||
|
|
|
|
|
| ||
Inaccurate heart rate strap | 1. Electrical interference | 1. | Keep at least six feet away from | ||||
|
|
|
| Televisions, Computers and | |||
|
|
|
| Fluorescent Lights | |||
CAUTION
safety switch
on/off switch
power cord
The Treadmill will shut off when the electricity load is above it’s capacity (example: power surge or storm). To restart the Treadmill, please follow the procedure below:
A.Unplug the power cord from the Treadmill’s socket.
B.Push in the safety switch.
C.Plug the power cord back into the Treadmill’s socket.
NOTE: DON'T PUSH IN THE SAFETY SWITCH BEFORE UNPLUGGING THE TREADMILL’S POWER CORD.
29
