WARNING: Always turn off and unplug the Treadmill from the electrical outlet before cleaning, lubricating, or servicing the Treadmill.
CLEANING
Keeping the Treadmill clean will prolong the life of the Treadmill and improve performance.
Regularly dust the unit, especially the exposed part of the Deck between the Belt and the Side Rails.
For best performance, we recommend your Treadmill be placed on a Treadmill Mat. A Treadmill Mat will help to keep dust debris away from your Treadmill's electrical components.
Clean the top of the Belt with a damp cloth. Be careful to keep liquid away from inside the frame or underneath the Belt.
At least once a year remove the Motor Cover and vacuum under the Motor Cover.
To remove the Cover: After turning off and unplug- ging the Treadmill, loosen the screws (you do not have to remove the screws) on each side (2) and in the front (2) of the Motor Cover and carefully lift the Cover off. Be careful, especially around the wiring on the lower board.
WARNING: Always turn off and unplug the Treadmill from the electrical outlet before removing the Motor Cover.
motor cover
safety | screw (3) |
switch |
screw | on/off switch | |
(2 each side) | ||
| ||
| power cord |
WALKING BELT AND DECK LUBRICATION
Your Treadmill Belt has been lubricated at the factory, but periodic lubrication will extend the life of your Treadmill Belt, Board, and Electrical Components. We recommend the following lubrication schedule based on weekly usage:
5+ hours per week | Monthly |
3 - 5 hours per week | Every three months |
0 - 3 hours per week | Every six months |
LUBRICATION APPLICATION
1.Put a liberal quantity of lubricant onto foam side of the Applicator Wand. Apply lubricant evenly across the foam pad.
foam pad
applicator wand
2.Insert the Applicator Wand into the lubrication port on the right hand side of the Treadmill, under the Walking Belt with the lubricated side of the Applicator Wand up, against the Belt.
Slide it completely across the Walking Deck into the lubrication port on the left side of the Treadmill.
NOTE: Make sure the Applicator Wand is securely in the left side lubrication port.
lubrication
port
LEFT SIDE
applicator
wand RIGHT SIDE
3.Start the Treadmill Belt and set the speed at 1.0 mph. Let the Belt run for about 45 seconds in order to spread the lubrication on the underneath side of the Belt.
4.Place Applicator Wand in plastic sleeve to retain moisture.
14
