Fluke 1502A 5.2 Rear Panel

5.2 Rear Panel

See Figure3 .

Serial Port- The DB-9 connector is for interfacing the thermometer to a com-

puter or terminalwith serial RS-232 communications.

ProbeConnector - At the rear of the thermometer is the probe connector. The

probe must be connected for operation.

PowerSwitch - The power switch is located on the rear of the thermometer.

The ACpower switch turns the unit on and off.

AC Power - At the rear of the instrument is the removable power cord that

plugsinto a standard 115 VAC grounded socket. (230 VACoptional)

IEEE-488 Port (optional)- The GPIB connector is for interfacing the ther-

mometer to a computer or terminalwith IEEE-488 communications.

1502A Thermometer Readout

User’s Guide

RS-232

IEEE-488

PROBE

POWER

l

201811

FLUKE CORPORATION

HART SCIENTIFIC DIVISION

www.hartscientific.com

115VAC 50/60 Hz 10W

NO USER SERVICABLE PARTS

Figure3 1502A Back Panel

Contents

Main Rev. 722101 Table of Contents 7 Digital Communications Interface . . . . . . . . . . . . . . . 23 ii 7.3 Remote Commands . . . . . . . . . . . . . . . . . . . . . . . . . 26 8 Calibration Procedure . . . . . . . . . . . . . . . . . . . . . . 35 Page Page 1 Before You Start 1.1 Symbols Used 1.2 Safety Information 1.2.1 Warnings 1.2.2 Cautions 1.3 Authorized Service Centers Page 2 Introduction 3 Specifications and Environmental Conditions 3.1 Specifications 9 3 Specifications and Environmental Conditions Specifications 3.2 Environmental Conditions 4 Quick Start 4.1 Unpacking 4.2 Power 4.3 Connecting the Probe Page 5 Parts and Controls 5.1 Front Panel Buttons 84.981 C 5.2 Rear Panel l 6 General Operation 6.1 Selecting Units 6.2 Parameter Menus 6.3 Menu Lockout Page 6.4 Selecting the Probe Characterization E -04 6.4.3 ITS-90 PRT and Coefficients Page [] () [] 6.4.4 Callendar-VanDusen (RTD) Conversion The RTDconversion uses the Callendar-VanDusen equation: 6.4.5 IPTS-68 Conversion A4 +4.336079 E -04 6.5 Filtering 6.6 Setting the Current 6.7 Power Saver 7 Digital Communications Interface 7.1 Serial Interface 7.1.1 Setting the Baud Rate 7.1.2 Automatic Transmission of Measurements 7.1.3 Time Stamp and System Clock 7.1.4 Duplex Mode and Linefeed 7.2 GPIB Interface 7.2.1 Setting the Address 7.2.2 Setting the Termination Character 7.2.3 Time Stamp 7.3 Remote Commands 7.3.1 Measurement Commands 27 7 Digital Communications Interface Remote Commands Table 6 Command List Page 7.3.2 Probe Characterization Commands 7.3.3 Sample Commands 7.3.4 Communication Commands 7.3.5 Calibration Commands 7.3.6 Other Commands Page 8 Calibration Procedure 8.1 Accessing the Calibration Parameters 8.2 Calibration Procedure 9 Maintenance 10 Troubleshooting 10.1 CE Comments 10.1.1 EMC Directive 10.1.2 Low Voltage Directive (Safety)