NAT/Route mode installation | Using the command line interface |
|
|
| Example |
| config system interface |
| edit internal |
| set mode static |
| set ip <192.168.120.99> <255.255.255.0> |
| end |
3Set the IP address and netmask of the WAN1 interface to the IP address and netmask that you recorded in Table 6 on page 28.
To set the static IP address and netmask, enter:
config system interface edit wan1
set mode static
set ip <address_ip> <netmask>
end
Example
config system interface edit wan1
set mode static
set ip 204.23.1.5 255.255.255.0
end
To set the WAN1 interface to use DHCP, enter:
config system interface edit wan1
set mode dhcp
end
To set the WAN1 interface to use PPPoE, enter:
config system interface edit wan1
set mode pppoe
set connection enable set username <name_str> set password <passwrd>
end
4Use the same syntax to set the IP address of each FortiGate interface as required.
5Confirm that the addresses are correct. Enter:
get system interface
The CLI lists the IP address, netmask, and other settings for each of the FortiGate interfaces.
31 |
