Transparent mode installation Using the command line interface
FortiGate-60 Installation Guide 01-28008-0018-20050128 41
To configure DNS server settings
1Go to System > Network > DNS.
2Enter the IP address of the primary DNS server.
3Enter the IP address of the secondary DNS server.
4Select OK.
To configure the default gateway
1Go to System > Network > Management.
2Set Default Gateway to the default gateway IP address that you recorded in Table9
on page 40.
3Select Apply.

Reconnecting to the web-based manager

If you changed the IP address of the management interface while you were using the
setup wizard, you must reconnect to the web-based manager using the new IP
address. Browse to https:// followed by the new IP address of the management
interface. Otherwise, you can reconnect to the web-based manager by browsing to
https://10.10.10.1. If you connect to the management interface through a router, make
sure that you have added a default gateway for that router to the management IP
default gateway field.
Using the command line interface
As an alternative to the web-based manager or setup wizard you can begin the initial
configuration of the FortiGate unit using the command line interface (CLI). To connect
to the CLI, see “Connecting to the command line interface (CLI)” on page 17. Use the
information that you gathered in Table9 on page 40 to complete the following
procedures.
To change to Transparent mode using the CLI
1Make sure that you are logged into the CLI.
2Switch to Transparent mode. Enter:
config system global
set opmode transparent
end
The FortiGate unit restarts. After a few seconds, the login prompt appears.
3Type admin and pr ess Enter.
The following prompt appears:
Welcome !
4Confirm that the FortiGate unit has switched to Transparent mode. Enter:
get system status