Foster S4000 Poor Operation, Poor Drying Results, EN 13/ IF OPERATING ANOMALIES OCCUR, Problem

EN 13/ IF OPERATING ANOMALIES OCCUR

• POOR OPERATION

	Problem	Possible Causes				What to do ?
	Constant filling	- (Cf. table fault d12). Drain hole				- Drain wand fallen on the floor.
		situated too low for the
		appliance.
	A lot of waste on the large filter	- The filters and drain outlets are				- Remove and clean the filters
	at the end of the cycle.	blocked	with	too	much	and the bottom of the drain
		residue.				outlets. Remove large residue
						from the plates before putting
						them in the machine.
	Traces of rust on stainless steel	- Quality of the stainless steel				- Use “special dishwasher-safe”
		not dishwasher-safe (knives in				cutlery.
		particular)				- Check that the stopper on the
						salt container is closed correctly.
• POOR DRYING RESULTS
	Problem	Possible Causes				What to do?
	A lot of droplets on the glasses.	- Lack or insufficient amount of				- Check the indicator light and
		rinsing product.				fill the tank completely.
		- The dose has not been distrib-				- If the tank is not empty after
		uted.				approximately 60 washings,
		- Positioning of the items.				call a technician.
						- To alleviate the phenomenon,
						arrange the items to restrict
						water retention as much as
						possible. Leave the door ajar
						for a few minutes, if possible
	Droplets on plastic items, Tefal	- These insulating items have a				- Arrange them preferably in the
	coatings, etc.	low calorific mass.				upper basket.
	Poorer drying on rapid	- On rapid programmes, the drying				- Select a rapid programme
	programmes	temperature and drying period are				carefully or leave the door ajar
		reduced to cut down the duration				for a few minutes.
		of the cycle as much as possible.
	Condensation on the wall of the	- Condensation may form on the
	inside door or the tub.	walls, particularly after the
		appliance	has	cooled	down
		(sound insulation increases the
		phenomenon)

56